W is for We Do This Shit . . .

. . . so you don't have to!

You may remember when Peter Evans sent the home-making moulds by Irwin RX to the blog? Four years ago, where does it go! Anyway, having not bought a couple of the 'ovens' in charity shops because they were too expensive (I'm not paying 20-quid for a second hand novelty-toy in a broken box!), I did find a cheap one, so we can now look at them properly!

 

 

A reminder of the set Peter sent to the blog, although the 'oven' is prominent all over the box, you actually get a few plastic moulds with reminders to buy a "3D Magic Maker available separately"! Which I had previously shelfie-shot, in TKMaxx I think?

The 3D Magic Maker, it looks like an oven and while there is nothing in the instructions (or online, then (2018/19) or now), I am 100% sure it is nothing more than a couple of small ultraviolet (UV) 'tanning' lamps!

 

The gel is quite soft, think mayonnaise, and here you can see an empty cavity on the left, new 'squeeze' in the middle and smoothing the gel into the cavity on the right, I used a cocktail stick, but something like a credit-card would be better, a Plasticard offcut, something like that?

 

Once you are satisfied that the moulds are prepped as good as you can get a semitransparent gloop, into the 'oven' it goes, and after a few minutes, out come the slightly warm, soft rubber figures, as halves!

After trimming ('fettling' the 'flash') you glue the two halves together with a slip of the gel, and give them a couple more minutes under the lamps, a single base needs to be manufactured twice more, and if you're still persevering with the project, similarly glued. I think we can assume I won't be making any more.

I can see this being fun for kids between about seven and maybe eleven years of age, but the fun will be in the doing and the mess, not the finished product! The gel however, in combination with the 'oven', may have further uses for hobbyists, for scratch-building, by producing specific parts, bits or scenic items?

 

There are other ranges of UV-setting resins out there, so A) there must be other similar products and B) you could extend your available pallet and even mix shades before 'cooking'? So I may well have a go at something more 'free hand', at some later date!

 

Most of the data online pertains to 2016, so they were probably already in clearance by the time I found the one in TKMaxx, and while there are a few other moulds out there (sea life etc...), Irwin RX seem to have had a better launch/presence in the US than Europe (distributed by Boti), although Russia seems to have got them as well.

As always; many thanks to Peter for the donation of the moulds.