FMC is for Water Buffalo!

A lot of the purchases at Sandown Park, earlier this month, were suited to stand-alone posts, and this is a classic - in World War II, while we, in the UK, were melting down railings to make bombs, and German housewives were being told not to whine about a lack of bananas, the Americans could afford to make corporate desk-toy freebies, in bronze!

 

I'm not 100% sure which model this is actually representing, but I think it's the 'Amtank' (LVT (A)-1) (37mm main gun), or something similar like the LVT(A)-4 (75mm main gun), both built on LVT-2 chassis (there were lots of marks and body-types!), also known variously as an Amtrac, Buffalo or Water Buffalo, and this model appears to be a braised bronze model, of the desk-ornament/advertising variety, with a fixed turret.

 

And while the origins date back to 1935 and the civilian design 'Alligator', this is definitely a wartime, USMC procurement-driven version, so such a model is as conspicuous a sign of wealth/consumption, as you're likely to find! And, from the heft, a very useful paperweight!

 

The barrel of the gun is a steel rod, embedded in the mantlet and blacked-down to match the patina of the vehicle/model, which may have had a chemical dip, to get this antiqued look?

 

FMC is really for Food Machinery Corporation! A 'toolmaker' in common parlance, you can see the welts of the braising where the maker's plate has been added last. It could be welded steel, but it's too heavy, equally, it's not soft-enough to be a base-metal, so bronze is the obvious material, although it appears to have been slush-cast (bronze is more commonly sand-cast?), and then tidied-up with both the baseplate, and possibly an oval plate on the rear face of the hull? From the polishing on the left side, a copper-rich bronze!

 

 After a clean!

 

An oddity, a probable rarity, and over 80-years old, it's possibly not far off the same size as the Airfix Buffalo II, an open-topped troop-delivery vehicle, for which this is the fire-support variant, usually found on either wing/end of the landing line, to suppress enemy fire and engage bunkers. But it might be a bit bigger, people who know me, know how bad my 'scale eye' is, it might be closer to 1:48th or a round 1:50th?

 

If anyone with better maths than me would like to try working it out, the tape measure says it's 125mm long, 50mm wide and approximately 65mm high?